How to fit a Tow-Pro Wiring Kit to a Prado

Installing a REDARC Tow-Pro Elite into a Landcruiser Prado

These instructions relate to the installation of the REDARC Tow-Pro Elite into a Landcruiser Prado using the the TPWKit-013 wiring kit.

Step 1

Use the 16mm grommet supplied.

Feed the terminated ends of both single and twin-core cable through (approx 600mm) and tape to seal.

Remove small grommet next to main harness (passenger side firewall) and feed cables through

NOTE - you can unseat the main grommet to aid.

Step 2

Fit the Main Unit to the bracket using fixings supplied.

Bend larger slot end (approx 15mm)

Secure using existing trim fixing as indicated.

Image shows area LH of glovebox.

Route Remote Head cable to lower centre console.

Switch Insert (TPSI-002) can be used to replace switch blank, If you wish to fit Remote Head to drivers RH panel, purchase 2m RH cable (RHWK-002).

Download this tech tip as a PDF here or check the REDARC range of switch inserts and Tow-Pro accessories to find one that matches your vehicle.