Close
Cart
You have no items in your shopping cart.
Filters

How to fit a Tow-Pro Wiring Kit to a Mitsubishi Triton

Installing a REDARC Tow-Pro Elite into a Mitsubishi Triton/Pajero Sport

 

 

These instructions relate to the installation of the REDARC Tow-Pro Elite into a Mitsubishi Triton or Pajero Sport using the the TPWKit-014 wiring kit.

 

Step 1

 

Locate vehicle grommet under front passenger seat (shown looking upwards) - this is the preferred entry point to the cabin.

 

Mitsubishi Triton Tow-Pro Entry Point

 

An alternative would be to drill a 16mm hole in the floor (closer to the passenger kick-trim area) and use the supplied smallest grommet (after applying paint treatment to drilled area).

 

From rear of vehicle, route teminated end of twin-core BLUE/RED forwards to this point (easier to pull through).

 

Feed both cables through the grommet - ensure at least 1.3m to reach the intended Main Unit mounting (you may need to check the BLACK wire route to achieve this).

 

 

Step 2

 

Fit Main Unit onto bracket and bend tip - fit to bottom fixing on fusebox (left side of glovebox area) using supplied M6 flanged nut.

 

Ensure clear of trim when refitting.

 

Route Remote Head cable to lower centre console.

 

Triton Mounting Tow-Pro Bracket

 

For best fit, remove spare switch blank and replace with TPSI-002 (purchased separately) and fit remote head.

 

If preferred, use 2m Remote Head cable (RHWK-002 purchased separately) to locate Remote Head to right hand side of steering column.

 

Download this tech tip as a PDF here or check the REDARC range of switch inserts and Tow-Pro accessories to find one that matches your vehicle.