Warenkorb (0)
Sie haben keine Artikel im Korb.

How to fit a Tow-Pro Wiring Kit to a 200 Series Landcruiser

Installing a REDARC Tow-Pro Elite into a LandCruiser 200 Series



These instructions relate to the installation of the REDARC Tow-Pro Elite into a 200 Series Landcruiser using the the TPWKit-014 wiring kit.


Step 1


Locate main grommet Drivers Side. Cut end of spare nipple (1).


LandCruiser 200 Tow-Pro Entry


Feed single core BLACK wire (terminated end) though to interior. Tightly tape the 2-Core RED/BLUE terminated ends and part of the cable to the single core and pull through.


200 Series Tow-Pro Grommet 


NOTE - Take care not to damage terminals, and use water (or water/soap mix) as lubricant.


Step 2


Fit Main Unit bracket as indicated below.


LC200 Tow-Pro Bracket


Secure to vehicle fixing indicated (seen after removing drivers main side switch assembly - right hand side of steering).


LC200 Tow-Pro Mounting Location

Download this tech tip as a PDF here or check the REDARC range of switch inserts and Tow-Pro accessories to find one that matches your vehicle.