You have no items in your shopping cart.

How to fit a Tow-Pro Wiring Kit to an Isuzu D-MAX/MU-X

Installing a REDARC Tow-Pro Elite into an Isuzu D-Max or MU-X



These instructions relate to the installation of the REDARC Tow-Pro Elite into an Isuzu using the the TPWkit-013 wiring kit.


Step 1


Locate and remove entry grommet rearwards of front left wheel (image shows route after splash shield removed).


Route terminal end of fused BLACK wire from battery as indicated (fuse will not pass through holes).


Use supplied 25mm grommet - cut end off both nipples and feed both twin-core RED/BLUE and single-core BLACK from outside to in - terminated ends.

 Isuzu Tow-Pro install entry point



Note, externally twin-core RED/BLUE runs down and along chassis to rear.


Step 2


Inside the cabin (looking at left of glovebox area).


To assit feeding wires, undo fixing indicated and dislodge large connector from large panel hole.


isuzu tow-pro install glovebox


Step 3


Fit Main Unit on bracket as shown below (lower left of glovebox cavity - glovebox removed).


Secure to existing vehicle fixing indicated - including EARTH (WHITE) terminal.


Isuzu Tow-Pro Main Unit Mounting


Download this tech tip as a PDF here or check the REDARC range of switch inserts and Tow-Pro accessories to find one that matches your vehicle.

Afterpay. Shop now. Pay later.

All you need to apply is to have a debit or credit card, to be over 18 years of age, and to be a resident of Australia.

Late fees and additional eligibility criteria apply. The first payment may be due at the time of purchase. For complete terms visit