Warenkorb (0)
Sie haben keine Artikel im Korb.

How to enjoy the great Aussie Outback - part 2

In our last blog, you heard about the Ultimate Camper My Aussie Travel Guide (MATG) uses when out exploring. In this one, let’s tell you about their tow vehicle.

Now when it came to choosing a touring vehicle, they undertook extensive research and narrowed it down to a few vehicle types. But in the end, the Dual Cab 79 Series Toyota Landcruiser stood out over all others. Having now had the vehicle for a little over 2 years, they've done some extensive travelling to remote parts of the Kimberley, and travelled through the Western Australian Gibson and Great Sandy Deserts last year.

For these past two years, they have learnt what was working for them, and what needed to change. So where are they today?

Well, firstly they have completely stripped and removed the vehicle’s canopy for extensive modifications to improve storage capacity and its overall strength, and at the same time lightened the load.

Now they have a place for everything and in its right place, but they also have flexibility depending on the type of trip they have planned (ie with the camper or perhaps no camper but a roof top tent or a river run with canoes and/or a tinnie). This meant the vehicle set up needed to stand alone and be completely self-sufficient.

So basically the design works with a kitchen pantry on the passenger side housing a small upright Waeco fridge, pantry door, a slide out table, and a day cupboard housing the essentials for meal preparation and on the go eating.

The other side is the equipment storage which houses two deep drawers of tools and spare parts, and an access shelf for storing other items like 150W monocrystalline solar panels, cables for quick access, the fuse board, relays, and all the control switches including a master cut off switch.

REDARC fuses and relays being wired

In the rear door area, they use stackable storage bins for a range of items. And under the false floor, there’s more spare parts, recovery gear, tyre changing tools, and two Revolution 100A/H Lithium batteries. These are charged and managed through REDARC's Battery Management System , The Manager30, with lithium capability.

This set up is quite interchangeable, and they can have it back to one big opening with just the Battery Management System and two Lithium batteries in situ should they need it in less than 30 minutes.

In addition, the canopy houses lighting solution for all the drawers and cupboards. They also have a 60 litre water tank with a 12v pump, some camping lights to assist setting up, and a number of 12v type plugs they can use for recharging all of our electronic equipment.

Externally, Anderson plugs have been fitted for taking solar panels directly to the Battery Managment System, and external 12v outlets for powering camp lighting and running 12v accessories and power tools.

On top of the canopy sits a roof rack that can carry the roof top tent (if required) or various other items such as swags, storage boxes, or extra jerry cans of fuel.

Now the rear section of their dual cab is still a work in progress. Here they have a 75 litre chest type freezer that houses a lot of thier food for meals. In addition, they also have an in-cab small console fridge that is used daily for drinks, snacks and quick on the go lunches. Electronic gear also lives here for quick and easy dust free access.

They've added a REDARC 1000 watt Pure Sine Wave Inverter that has been neatly tucked away in the rear of the cab, and an inverter remote switch that allows access the unit through a 240v distribution board so they can recharge 18v battery packs, camera gear, and an assortment of laptops and other electronic equipment.

As this area is still a work in progress, new storage cupboards and overhead rear consoles are planned in the design that will accommodate the REDARC battery management system output display, so they can see that all things are in order at a glance.

Up front in the cockpit area, they have several 12v outlets that are used to power a variety of navigational devices such as computers, Ipads, and dedicated navigational devices. There’s also some switches for driving lights, light bars, on board air compressors, and the other usual 4WD accessories.

For towing, they have equipped the vehicle with a Electric Brake Controller which they say have found works really well, and is simply outstanding when going offroad , especially in steep downhill soft sand and rocky terrain descents.

To keep a watchful eye on things, they have fitted two REDARC pod gauges; a voltage gauge that provides real time feedback, on their 12v systems, amps being used and recharged, and a turbo boost gauge to monitor PSI, EGT PSI and engine oil PSI. These have threshold alarms set in case operating parameters are outside the set specified levels.

The starting battery and an additional deep cycle battery are under the bonnet that can be joined with the starter battery for heavy loading such as winching. The deep cycle battery circuit has been set up in such a way that in the case of redundancy, it can be used to power the canopy loads, the cab, and/or be used to start the vehicle. This additional deep cycle battery is managed through the REDARC BCDC In-vehicle charger located behind the grille, and has this battery fully charged in no time.

They've also added REDARC fuses and 30A circuit breakers throughout the vehicle to ensure the ultimate in circuit protection.

Now this might sound all straightforward, but a lot of thought went into the design, and particularly how the 12v electrical solution was going to work.

putting all REDARC products to the test

Grant and Linda would like to thank the team at REDARC and Morphett Vale Auto Electrics, and are now testing it all out on their outing to Cape York.

Stay tuned, as next time they explain just how they came up with such a design.

Words by Grant and Linda, My Aussie Travel Guide 

Want to know more? follow them here:


Hinterlasse einen Kommentar