Redarc Electronics The Specialists in Power Conversions
Redarc ElectronicsThe Specialists in Power Conversions
* *
*HEADLIGHT AND BUS FLASHERS **
*

Headlight and Bus flashers

REDARC ELECTRONICS
ABN 77 136 785 092
23 Brodie Road North , Lonsdale
South Australia, 5160, AUSTRALIA

Phone
+61 8 8322 4848
Fax
+61 8 8387 2889


Quality logo   ctick
*
Print Friendly  


Flasher units for emergency vehicles and buses
Alternating Headlight Flashers

The microprocessor controlled REDARC AHLF200 is suitable for FIRE and other emergency vehicles. It has two outputs, each rated at 200W, to provide alternating LEFT-RIGHT headlight flashing for 12V or 24V negative earth vehicles. When the AHLF200 is on and the PARK light switch is off, the headlights flash alternately. When the PARK light switch is on, the AHLF200 is disabled (the PARK lights over-ride the AHLF200). This allows both headlights to operate normally, regardless of the position of the "ON" switch.

The AHLF200 is rated at 200W per side and may be used to flash either HIGH or LOW beams.

The flash rate is 90 flashes per minute.


Standard features available

  • Solid State Controller for long life, and accurate switching.
  • Mechanical relays are not used for flashing functions.
  • Designed for Emergency Vehicle applications.
  • Custom flash rates can be easily catered for.
  • Each headlight output is rated at 200watts.
  • Multi voltage capability - Can operate from 12VDC or 24VDC vehicles.
  • Short circuit / overload protected.
    Alternating Headlight Flasher ----REDARC Part Number - AHLF200


Multiple bus light flashers

The microprocessor controlled REDARC BUSF200 has five outputs for school bus hazard lights on 12V or 24V negative earth vehicles. The alternating outputs and strobe output draw their current from the main supply input, with a small current drawn by the "ON" switch. The alternating headlight outputs, the strobe output and the high beam disable operate only while the door is open. The alternating amber flashing lights ("WIG-WAG") outputs operate while the door is open and for 20 seconds after it is closed.

The two "DOOR OPEN" inputs allow for either a positive or ground signal to trigger the BUSF200, depending on vehicle door switch wiring.


Standard features available

  • Solid State controller for long life, and accurate switching.
  • Mechanical relays are not used for flashing functions.
  • Short circuit and overload protection.
  • Suitable for a wide range of vehicles.
  • Each headlight output is rated at 200watts.
  • Designed to meet stringent ADR requirements.
  • Multi voltage capability - Can operate from 12VDC or 24VDC vehicles.
  • One unit covers all synchronous bus operational requirements including:
    • Headlight flashers, rear light (Wig Wag) flashers.
    • "Wig Wag" delay.
    Multiple Bus Light Flasher --------REDARC Part Number - BUSF200

to top of page



REDARC ELECTRONICS
ABN 77 136 785 092
23 Brodie Road North, Lonsdale
South Australia, 5160, AUSTRALIA
ctick - quality logo Phone +61 8 8322 4848
Fax +61 8 8387 2889
Email power@redarc.com.au
Web www.redarc.com.au

* *
ALTERNATING HEADLIGHT FLASHER AHLF200
Dual Voltage –suitable for both 12 volt and 24 volt DC vehicles
Variable flashing pattern by software
Extremely robust
Suits a wide range of vehicles

NOTE: Check with your relevant state or territory transport authority before installing alternating headlight flashers

MULTIPLE BUS LIGHT FLASHER BUSF200
Suits a wide range of vehicles
Alternates headlights, amber lights and timed signal from door
Extremely robust
Dual Voltage –suitable for both 12 volt and 24 volt DC vehicles
*